ar6125d615503ts

Weld in spring bracket of rear axle spring

Typ ar · temat 61.25 · wersja 0100 · 2017-12-15

Dotyczy: Model 907.1/2, 910.1

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 61 Część dolna › 61.25 Szkielet części dolnej — Seria 907 (modele 1**, 2**) · Seria 910 (modele 1**)

EinPAS 35 Karoseria/ rama/ elementy domontowane › 35.32 Podwozie › 35.32.35 Płyta podłogowa/szkielet podwozia — Seria 907 (modele 1**, 2**) · Seria 910 (modele 1**)

AR61.25-D-6155-03TS

Weld in spring bracket of rear axle spring

Danger

The high voltage used for electric welding presents a lethal hazard. Risk of explosion from welding in areas close to highly inflammable materials. Risk of injury from weld splatter and UV-light when welding. Risk of poisoning from inhaling welding gases

Use insulating mats. Wear protective clothing, safety glasses and a protective mask. Remove highly inflammable materials from the hazard area. Use air extraction system.

AS00.00-Z-0007-01A

Caution

Risk of injury caused by scraping or cutting body parts on sharp vehicle parts

Always wear protective gloves when working on or near sharp and non-deburred vehicle parts.
Deburr repair panels.

AS00.00-Z-0017-01A

Topical note

Measures for preventing damage to vehicles or components when performing electric welding work

AH00.00-N-0005-01A

000 588 02 84 00 Welder

WS60.00-P-0022K

Model

907.1/2, 910.1

The next steps are shown on the left side of the vehicle for model 907.233 and must be performed in a similar way in the event of damage on the right side of the vehicle.

Weld in spring bracket of rear axle spring

1

Install lower section of spring bracket (1), fit, and fix in place.



2

Lower section of spring bracket (1) (areas B and C).


D61.25-0128-06

Weld in spring bracket of rear axle spring

3

Lower section of spring bracket (1) (areas E and I).



4.1

Model 907.1/2
Lower section of spring bracket (1) (areas F, G, and H).



4.2

Model 910.1
Lower section of spring bracket (1) (areas F1 and H1).


D61.25-0131-06

Weld in spring bracket of rear axle spring

D61.25-0129-09

5

Install upper section of spring bracket (2), fit, and fix in place.

6

Upper section of spring bracket (2) (areas M and N).

7

Upper section of spring bracket (2) (areas A, P, and O).

8

Clean weld joints.

Powiązane dokumenty