ar6125d615502ts

Prepare spring bracket of rear axle spring for installation

Typ ar · temat 61.25 · wersja 0100 · 2017-12-15

Dotyczy: Model 907.1/2, 910.1

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 61 Część dolna › 61.25 Szkielet części dolnej — Seria 907 (modele 1**, 2**) · Seria 910 (modele 1**)

EinPAS 35 Karoseria/ rama/ elementy domontowane › 35.32 Podwozie › 35.32.35 Płyta podłogowa/szkielet podwozia — Seria 907 (modele 1**, 2**) · Seria 910 (modele 1**)

AR61.25-D-6155-02TS

Prepare spring bracket of rear axle spring for installation

Caution

Risk of injury caused by scraping or cutting body parts on sharp vehicle parts

Always wear protective gloves when working on or near sharp and non-deburred vehicle parts.
Deburr repair panels.

AS00.00-Z-0017-01A

Model

907.1/2, 910.1

The next steps are shown on the left component part and must be performed in a similar way in the event of damage on the right side of the vehicle.

Prepare spring bracket of rear axle spring for installation

D61.25-0132-09

1

Drill holes on lower section of spring bracket (1) with a diameter of 7 mm (areas A, B, C, D, E, and F).

2.1

Model 907.1/2
Drill holes on lower section of spring bracket (1) with a diameter of 7 mm (area G).

2.2

Model 910.1
Drill holes on lower section of spring bracket (1) with a diameter of 7 mm (areas B1 and E1).

3.1

Model 907.1/2
Grind down cross-hatched area around holes (area G) to bare metal on both sides.

3.2

Model 910.1
Grind down cross-hatched areas around holes (areas B1 and E1) to bare metal on both sides.

4

Grind down mating surfaces in cross-hatched areas and around holes (areas A, B, C, D, E, and F) to bare metal.

Prepare spring bracket of rear axle spring for installation

5

Drill holes on upper section of spring bracket (2) with a diameter of 7 mm (areas H, I, J, and K).



6

Grind down mating surfaces in cross-hatched areas and around holes (areas H, I, J, and K) to bare metal.



7

Remove shavings and drill chips.


D61.25-0127-06

Powiązane dokumenty