S61.10-4604-09
b | Dimension approx. 10 mm |
1 | Mark separating point on rear floor (1) and cut (areas A and B). |
Cut connecting point at end of lower radius (area A). |
S61.10-4607-09
2 | Punch holes for MAG welding on rear floor (1) (areas C, G and H). |
3 | Drill holes for MAG welding on rear floor (1) (areas D, E, F and I). |
4 | Grind mating surfaces on rear floor (1) down to bare metal around holes (areas C, D, E, F, G, H and I) n crosshatched areas. |
Sand down spot weld flanges to bare metal on both sides. |
5 | Remove shavings and drill chips. |
6 | Coat insides of spot weld flanges with zinc dust paint. |
7 | Grind mating surfaces on rear floor (1) down to bare metal in crosshatched areas. |
Sand down spot weld flanges to bare metal on both sides. |
8 | Remove shavings and drill chips. |
9 | Coat insides of spot weld flanges with zinc dust paint. |
S61.10-4611-03