Commercially available tools
Number | Designation | |
WH58.30-Z-1007-06A | Reversible ratchet | |
WH58.30-Z-1001-11A | Double end box wrench, offset, 17 x 19 mm |
Workshop equipment
WE58.40-Z-1039-01A | Celette straightening bracket set 7211.300 (model 211) |
WE58.40-Z-1008-03A | Pneumatic ratchet |
P60.10-2131-09
Shown on body for model 211
Set-up for straightening tool MZ elements (front)
1 Left front frame-type integral support mount
2 Right front frame-type integral support mount
3 Mount for left front longitudinal member
4 Mount for right front longitudinal member
5 Fastening sleeve for front frame-type integral support mount
6 Mounts for left and right upper transverse control arm bearing
7 Basic carrier for left upper transverse control arm bearing mount
8 Basic carrier for right upper transverse control arm bearing mount
9 Left rear frame-type integral support mount
10 Right rear frame-type integral support mount
11 locating pin for rear frame-type integral support mount
12 Mounting screw for rear frame-type integral support mount
13 Basic carrier for front jack tubes
14 Front jack tubes
15 Locks for front and rear jack tube
16 Test pins for upper left and right transverse control arm bearing
17 Mount for left rear engine mount
18 Mount for right rear engine mount
19 locating pins for left and right engine mount mounts
21 Propeller shaft bearing mount
22 Basic carrier for check bore mount
23 Test pin on check bore
Set-up for straightening tool MZ elements (rear)
24 Rear jacket tube mounts
25 Basic carrier for rear jack tube mounts
26 Mount for right front rear axle
27 Mount for left front rear axle
28 Mounting screw for front rear axle mount
30 Locating pins for left and right front rear axle mount
31 Mount for left rear shock absorber
32 Mount for right rear shock absorber
33 Locating and test pin for rear shock absorber
34 Right rear axle mount
35 Left rear axle mount
36 Mounting screw for rear axle mount
37 Fastening sleeve for rear axle mount
38 Basic carrier for right rear longitudinal member mount and right rear lamp mount
39 Basic carrier for left rear longitudinal member mount and left rear lamp mount
40 Mount for right rear longitudinal member
41 Mount for left rear longitudinal member
42 Mount for left and right rear lamps
43 Spacers (for installing crossmember)
46 Spacers (for installing rear longitudinal member)
Basic set-up of the Celette straightening tool corresponds to model 211; on model 219, the straightening tools are eliminated: Right and left upper rear lamp mounts (42).
1 Install multi-Z elements and straightening set.
Number and position of MZ elements and straightening tools are given in the associated Celette setup plan.
Multi-Z elements:
When installing multi-Z elements on straightening bench observe direction of arrow on multi-Z elements
The parts numbers of the multi-Z elements are cast into the side
Straightening tool:
The arrow in the straightening tool should always point toward the front of the vehicle
In addition to the straightening tool number, the straightening tool for the left side have the letter "L" next to the arrow
The position number in combination with the 8-digit reference number (e.g.: 7211.7001), is also the order number for replacement parts
Right side of straightening bench is always installed analogously to left side of straightening bench.