Test and adjustment values for gaps
Number | Designation | Model 452.3 | |||
BE60.00-P-1001-01J | Gap dimensions | Front hood to front center section | Dimension «A» | mm | 6.0 (2.0) |
Front hood to front fender | Dimension «S» | mm | 5.0 (1.5) | ||
BE60.00-P-1002-01J | Gap dimensions | Front door to front fender | Dimension «D» | mm | 6.0 (1.5) |
Roll down window to side strut/hard top | Dimension «E» | mm | 9.0 (2.0) | ||
Front door to bottom side wall | Dimension «F» | mm | 7.0 (2.0) | ||
Front door to rear side wall | Dimension «G» | mm | 8.0 (2.0) | ||
Front door paneling to A-pillar | Dimension «H» | mm | 5.0 (1.5) | ||
BE60.00-P-1003-01J | Gap dimensions | Rear fender to rear end center assembly | Dimension «B» | mm | 2.0 (0.5) |
Rear fender to side window | Dimension «J» | mm | 6.0 (2.0) | ||
Rear fender to B-pillar | Dimension «I» | mm | 6.0 (0.5) | ||
BE60.00-P-1004-01J | Gap dimensions | Tailgate/trunk lid to rear end center section | Dimension «C» | mm | 6.0 (2.0) |
Trunk lid to rear window cross member | Dimension «M» | mm | - | ||
Tailgate to roll bar | Dimension «Q» | mm | 6.0 (1.0) | ||
Tailgate to side window | Dimension «R» | mm | 6.0 (+1.0/-3.0) | ||
BE60.00-P-1005-01J | Gap dimensions | Hard top, left side to hard top, right side | Dimension «L» | mm | 8.0 (2.0) |
Hard top to roof frame | Dimension «K» | mm | 6.0 (+2.0/-2.5) | ||
Folding soft top to roof frame | Dimension «P» | mm | 6.0 (1.5) | ||
Hard top/folding soft top to roll bar | Dimension «N» | mm | 6.0 (1.5) | ||
Folding soft top to side stay | Dimension «O» | mm | 6.0 (+2.0/-2.5) | ||
129 589 03 21 00
Feeler gage
P60.00-2264-06
Adjust hood, doors and trunk lid as shown in drawings. The gap should not run wedge-shaped or be too narrow at points. Deviations from parallel gap should be max. 0.5 mm over the entire length.
If the inside clearance is too large or too small, the movable body parts must be centered accordingly.
The reference measurements apply only for repair work on bodies damaged in accidents.
P60.00-2271-05