Remove/install backup camera

AR54.65-P-0030EQ

Remove/install backup camera

23.01.2020

Model

293

with code 218 (Rear view camera)

Model

293

with code 501 (360° camera)

Shown with CODE 218 (Reversing camera)

1

Bow

3

Electrical connector

2

Electrical connector

4

Backup camera

 Warning

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

Topical note

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

Notes on HANDS-FREE ACCESS

AH80.61-P-0001-01A

 

Remove/install

1

Switch off ignition and store transmitter key outside of transmission range (min. 2  m).

2

Remove center liftgate trim.

AR72.20-P-6618LWS

3

Release bracket (1).

 Installation: The bracket (1) must latch audibly into place.

4

Release electrical connectors (2, 3), disconnect and unclip.

 The number of electrical connectors (2, 3) can vary depending on equipment variant installed.

5

Remove reversing camera (4) by pulling inward.

6

Install in the reverse order.

7

Perform commissioning of reversing camera (4) using diagnostic system.

Model 293
with code 218 (Rear view camera)
except code 235 (Active Parking Assist)
When replacing reversing camera (4).

8.1

Calibrate reversing camera (4) using diagnostic system.

Model 293
with code 218 (Rear view camera)
except code 235 (Active Parking Assist)



AD00.00-P-2000-06FR

 Calibration device

*000589012100

8.2

Calibrate reversing camera (4) using diagnostic system.

Model 293
with code 218 (Rear view camera)
with code 235 (Active Parking Assist)
Model 293
with code 501 (360° camera)



AD00.00-P-2000-06FR