AR54.18-P-0085SN | Remove/install engine wiring harness | 8.7.04 |
MODEL 450.3 /4 (except , 450.418) with ENGINE 660.940
P54.18-3654-09
1 Pressure regulator valve connector
2 Water temperature sensor
3 Crankshaft sensor
7 Rail pressure sensor
8 Boost pressure sensor
4 Oil pressure switch
5 Connector for injectors
6 Cable duct rail
P54.18-3655-06
9 Ground strap
10 Bolts
11 Glow pin connector
Danger! | Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and undeburred vehicle parts. Deburr replacement panels. | |
| Remove/Install | ||
1 | Release rear drive module | ||
2 | Detach alternator | Only disconnect electrical connections. | |
3 | Disconnect pressure regulator valve connector (1). | ||
4 | Disconnect water temperature sensor (2). | ||
5 | Disconnect crankshaft sensor (3). | ||
6 | Disconnect oil pressure switch (4). | ||
7 | Disconnect connector for injectors (5). | ||
8 | Unclip cable duct rail (6) | Do not damage cable duct rail. | |
9 | Disconnect rail pressure sensor (7). | ||
10 | Disconnect boost pressure sensor (8). | ||
11 | Detach ground strap (9) from engine. | Remove bolt (arrow). | |
12 | Remove bolts (10) at fuel feed and return bracket and unclip bracket at cable duct. | Detach cable ties at cable duct. | |
13 | Disconnect glow pin connector (11). | ||
14 | Install in the reverse order |
Powiązane dokumenty
- ar0100p3050sm
- ar1540p5032sn
- as0000z001701a Niebezpieczeństwo obrażeńo elementy pojazdu o ostrych krawędziach.