Remove/install rear prefuse box in seat base under driver's seat

AR54.15-D-1355TS

Remove/install rear prefuse box in seat base under driver's seat

27.04.2018

Model

907, 910

Shown on removed driver's seat

1

Prefuse box

3

Seat frame

2

Relay holder

4

Catch hook

1

Prefuse box

6

Electrical lines

5

Cover

Topical note

Notes on carrying out repair work in the vehicle interior

AH68.00-N-0001-01S

 

Remove/install

1.1

Set driver's seat in the frontmost and topmost position.

Model 907, 910
except code SB3 (Suspension seat, comfort version, driver's seat)
except code SR8 (Swivel base for driver' seat)

AR91.10-D-1000TS

1.2

Remove turn plate with installed driver's seat.

Model 907, 910
with code SR8 (Swivel base for driver' seat)

AR91.10-D-1456TS

 Do not disconnect driver's seat from turn plate.

1.3

Remove driver seat.

Model 907, 910
with code SB3 (Suspension seat, comfort version, driver's seat)

AR91.10-D-1000TS

2

Detach ground line of on-board electrical system battery.

Model 907, 910
with code SH1 (Thorax/pelvis side-impact airbag, driver)
except code SB3 (Suspension seat, comfort version, driver's seat)
except code SR8 (Swivel base for driver' seat)

AR54.10-D-0029TS

3

Loosen seat base cover and remove from working area.

4

Remove relay holder (2) from seat base (3) and remove with connected electric lines from the working area.

If required.

5

Release prefuse box (1) at catch hooks (4) and pull upwards out of holder.

6

Release cover (5) at retaining tabs (arrows A) and remove from prefuse box (1).

 Clip remover

*452589016300

7

Mark position of electric lines (6).

8

Remove electric lines (6) from prefuse box (1) and remove prefuse box (1).

 Installation:
Note markings of electric lines (6).
Otherwise, the electric lines (6) may be swapped when connected and therefore cause damage to the electrical system.

 Installation: Observe torque specifications on housing of prefuse box (1).

 The number of electric lines (6) varies depending on the vehicle equipment.

9

Install in the reverse order.