Perform teach-in processes on exhaust gas aftertreatment control unit (ACM)
20.08.2018
Engine
936.9 in model 382.155/189
with code MS6 (Euro VI)
Program
1
Turn on the ignition
2
Connect the diagnosis system and start the XENTRY
If one of the following components is replaced, the exhaust gas after-treatment control unit (ACM) must be run in different procedures of re-programming: Exhaust gas after-treatment unit Diesel particulate filter (DPF)
3
From the list, select and start the corresponding re-programming procedure
The re-programming procedures are fully performed by the menu: Exhaust gas after-treatment control unit (ACM) Adaptation Re-programming procedure Re-programming of new components
4
Finish the XENTRY and disconnect the diagnosis system