P42.45-2465-06
6 Rear vent grille
7 Rear floor covering
9 Nuts
10 Electrical connector
B24/15 Turn rate and lateral acceleration sensor
Modification notes
25.11.08 | Road test procedure with STAR DIAGNOSIS restricted (after replacing sensor) | Step 15 | |
Perform initialization of DTR control unit after replacing sensor, added | Step 16 |
| Remove/install | ||
1 | Move the front passenger seat backrest into the upright position | ||
2 | Move the front passenger seat into the foremost position | ||
3 | Remove the rear bolts on the guide rails of the front passenger seat | Installation: Replace bolts and align guide rails. | |
| |||
4 | Unclip and remove vent grille (6) from floor covering (7) in the rear | ||
5 | Move the front passenger seat into the rearmost position | ||
6 | Remove the front bolts on the guide rails of the front passenger seat | Installation: Replace bolts and align guide rails. | |
| |||
7 | Check whether the ignition is switched off | ||
8 | Tilt front passenger seat backwards | Ensure that the guide rails do not damage the floor covering. | |
9 | Secure the front passenger seat | So that the front passenger seat cannot tilt forwards. | |
10 | Lift floor covering (7) under the front passenger seat | Do not damage the floor covering when lifting | |
The sensor (B24/15) can be reached via the cutout in the vent grille (6). | |||
11 | Disconnect the electrical connector (10) on the sensor (B24/15) | ||
12 | Unscrew nuts (9) of sensor (B24/15) | ||
13 | Remove sensor (B24/15) under the floor covering | Handle sensor (B24/15) with care. It is sensitive to shocks. | |
14 | Install in the reverse order | ||
15 | Carry out road test as per STAR DIAGNOSIS | After replacing the sensor (B24/15) | |
16 | Perform initialization of DTR control unit with STAR DIAGNOSIS | After replacing the sensor (B24/15) on vehicles with code (219) Distronic (DTR) |
Front seats