ar4230p0712mcc

Remove/install left front or right rpm sensor

Typ ar · temat 42.30 · wersja 0103 · 2011-11-14

Dotyczy: MODEL 451.3 /4

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 2 Podwozie › 42 Układ hydrauliczny i mechanizm hamulców › 42.30 Układ ABS — Seria 451 (modele 3**, 4**)

EinPAS 26 Aktywne systemy bezpieczeństwa › 26.20 System kontroli trakcji/ hamowania › 26.20.12 Czujnik/ przełącznik/ wiązka przewodów — Seria 451 (modele 3**, 4**)

AR42.30-P-0712MCC

Remove/install left front or right rpm sensor

10.11.11

MODEL 451.3 /4

Remove/install left front or right rpm sensor

P42.30-2131-06

1 Electrical line

2 Bracket

3 Screw

4 Brake line

5 Brackets

L6/1 Left front rpm sensor

L6/1x1 Rpm sensor connector

L6/2 Right front rpm sensor

L6/2x1 Rpm sensor connector

Remove/install

Danger!

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer.

AS00.00-Z-0010-01A

1

Raise vehicle with vehicle lift and remove underfloor paneling

Cordless drill/driver, cordless drill
gotis://G_58.0_01.1

2

Mark the position of brackets (5) on electrical line (1) and on brake line (4)

3

Unscrew bolt (3) on the left front rpm sensor (L6/1) or right front rpm sensor (L6/2)

Replace self-locking bolt (3).

4

Separate rpm sensor connector (L6/1x1) or rpm sensor connector (L6/2x1)

5

Loosen electrical line (1) of left front rpm sensor (L6/1) or right front rpm sensor (L6/2) from the brackets (2)

Observe correct routing of the electrical line (1) otherwise damage can occur to the electrical line (1) of the left front rpm sensor (L6/1) or right front rpm sensor (L6/2).

6

Unclip brackets (5) on brake line (4)

Observe installation position of brackets (5) on brake line (4).

The brackets (5) remain on the electrical line (1).

7

Pull the left front rpm sensor (L6/1) or right front rpm sensor (L6/2) out of the steering knuckle and remove

Installation: The contact surface of the left front rpm sensor (L6/1) or right front rpm sensor (L6/2) must be clean and free from rust. Clean contact surface if necessary.

8

Unclip brackets (5) on the electrical wiring harness (1) and attach at exactly the same point on the electrical line (1) of the new left front rpm sensor (L6/1) or new right front rpm sensor (L6/2)

When replacing the left front rpm sensor (L6/1) or right front rpm sensor (L6/2).

9

Install in the reverse order

10

Read out fault memory

Connect STAR DIAGNOSIS and read out fault memory

AD00.00-P-2000-04MCC

Powiązane dokumenty