Remove/install front brake control cable

AR42.20-P-0520TX

Remove/install front brake control cable

23.3.06

 

Remove/install

1

Raise vehicle with lifting platform

AR00.60-P-1000TX

2

Remove crossmember (35)



*BA62.30-P-1001-01C

3

Loosen and move heat shields (105d, 105e) or remove them

Depending on accessibility

AR49.00-P-1000-01TX

4

Unhook brake cable (85) from cable slack adjuster (91).

 To do this, pre-tension automatic cable slack adjuster (91):



Preload automatic slack adjuster.

AR42.20-P-0520-01TX

 Installation: To attach brake cable (85): 

Once again pre-tension automatic cable slack adjuster.

AR42.20-P-0520-01TX

 Installation: After attaching brake cable (85): 

Relieve load on automatic slack adjuster.

AR42.20-P-0520-02TX

5

Remove retaining clips (85a) from propeller shaft tunnel

 Installation: Replace retaining clips (85a).

6

Unclip brake cable (85) from bridge (70)



*129589116300

7

Remove front left floor covering

8

Remove retaining clips (85a) in footwell

 Installation: Install new retaining clips (85a).

9

Remove supporting wedge (17)

10

Unhook brake cable (85) from tensioning shackle (85b).

 Installation: Pay attention to the correct position of the rubber ring (85c) in the tensioning shackle (85b).

11

Unclip brake cable (85) from pedal assembly (71)

12

Lever rubber grommet (85d) out of propeller shaft tunnel and pull front brake cable (85) into passenger compartment.

 Installation: Working from within the passenger compartment, push the brake cable (85) to the outside.

13

Install in the reverse order



Checking

14

Check pedal travel at parking brake pedal; adjust parking brake if necessary

AR42.20-P-0540TX

Number

Designation

Model
219

BA62.30-P-1001-01C

Bolt, crossmember to body

Nm

25