P42.20-2229-09
35 Crossmember
71 Pedal assembly
72 Bolt
75 Parking brake pedal
76 Cover
85b Rubber ring
91 Cable slack adjuster
105d Heat shield
105e Heat shield
S12 Parking brake indicator switch
77 Cover
79 Unlocking cable
79a Tensioning shackle
85 Brake cable
85a Tensioning shackle
| Remove/install | ||
| Notes on self-locking nuts and bolts | ||
1 | Raise vehicle with lifting platform | ||
2 | Remove crossmember (35) | | |
3 | Loosen and move heat shields (105d, 105e) or remove them | Depending on accessibility | |
4 | Unhook brake cable (85) from cable slack adjuster (91). | To do this, pre-tension automatic cable slack adjuster (91): | |
Preload automatic slack adjuster. | |||
Installation: To attach brake cable (85): | |||
Pre-tension automatic cable slack adjuster (91) again. | |||
Installation: After attaching brake cable (85): | |||
Relieve load on automatic slack adjuster. | |||
5 | Remove left cover below instrument panel | ||
6 | Remove side paneling in left front footwell | ||
7 | Detach front cover (76) of pedal assembly (71) | ||
8 | Unlock and disconnect electrical connector on parking brake indicator switch (S12) | ||
9 | Remove bolt (72) and take off pedal assembly (71). | | |
10 | Remove cover (77) of pedal assembly (71). | ||
11 | Unhook brake cable (85) from tensioning shackle (85a). | Installation: Pay attention to the correct position of the rubber ring (85b) in the tensioning shackle (85a). | |
12 | Unclip brake cable (85) from pedal assembly (71) | | |
13 | Detach unlocking cable (79) from tensioning shackle (79a) | ||
14 | Unclip unlocking cable (79) from pedal assembly (71) with tool for unlocking cable | ||
| Tool for releasing parking brake control cable | ||
15 | Install in the reverse order | ||
| Checking | ||
16 | Check pedal travel at parking brake pedal (75); adjust parking brake if necessary |
Crossmember and front reinforcement
Parking brake
Number | Designation | Model | ||
BA42.20-P-1001-01G | Bolt, foot-operated parking brake pedal assembly at front wall pillar | Nm | 12 | |
Snap-release tool
129 589 11 63 00
Powiązane dokumenty
- ah0000n000101a Wskazówki dotyczące samozabezpieczających śrub i nakrętek
- ar0060p1000tx
- ar4220p052001tx
- ar4220p052002tx
- ar4220p0540tx
- ar4900p100001tx Demontaż i montaż osłony termicznej
- ar6810p1500tx
- wf5850p422001a Narzędzie do odryglowywania linki hamulca pomocniczego