P42.10-2659-06
1 Fixing spring
2 Adjuster
3 Brake shoes
4 Return spring
5 Spring
6 Threaded tool
7 Angled piece
8 Thumbwheel
9 Heat protection
| Remove/install | ||
1 | Remove left or right brake shoes (3) on the rear axle | ||
2 | Unhook fastening spring (1) on brake adjuster (2) and on brake shoes (3) | ||
3 | Unhook return spring (4) on brake shoes (3) | ||
4 | Unhook spring (5) on brake shoes (3) | Installation: Observe curvature of teeth on adjusting wheel (8). They must curve away in the direction of adjustment (arrow). | |
5 | Pull threaded union (6), spring (5) and adjustment wheel (8) out of the angle (7) in the brake adjuster (2) | The heat shield (9) must be located in the center of the angle cutout (7), as otherwise the drum brake function may be impaired. | |
Installation: Check the direction of the brake adjustment, in the process pressing against the elbow (7) and relieving the load again. Observe the installation position of the brake adjuster (2): - Right side = Left-hand thread on brake adjuster (2) - Left side = Right-hand thread on brake adjuster (2) The designations on the brake adjusters (2) are invalid. | |||
6 | Install in the reverse order | ||
7 | Adjust drum brake |