Measure absolute angle at rear axle housing

AR41.10-D-0085-03R	Measure absolute angle at rear axle housing
	000 588 04 19 00 Inclinometer		WS26.00-P-0140B

Model

909

Measure absolute angle at rear axle housing

Shown with 2-piece propeller shaft

1	Front propeller shaft
2	Rear propeller shaft
 A1	Absolute angle
 A2	Absolute angle
 A3	Absolute angle
 A4	Absolute angle
 K1	Articulation angle
 K2	Articulation angle
 K3	Articulation angle
A	Positive articulation angle upwards "+"
B	Negative inclination angle downwards "-"

D41.10-1138-04

Shown with 3-piece drive shaft

1	Front propeller shaft
2	Rear propeller shaft
3	Center propeller shaft
 A1	Absolute angle
 A2	Absolute angle
 A3	Absolute angle
 A4	Absolute angle
 A5	Absolute angle
 K1	Articulation angle
 K2	Articulation angle
 K3	Articulation angle
 K4	Articulation angle
A	Positive articulation angle upwards "+"
B	Negative inclination angle downwards "-"

D41.10-1139-04

Preparation for measurement of absolute angle ( A4 on vehicles with 2-piece propeller shaft and  A5 on vehicles with 3-piece propeller shaft)
 The vehicle must be on its wheels for the measurement.
Otherwise, the measurement will be inaccurate.

1	Clean contact surfaces on joint flange (4) of rear axle housing (arrows a).

D35.31-0006-01

2	Attach adaptation (01) to joint flange (4) of rear axle housing.

 Adaptation (01) for universal differential:
Article no.: 09935-24

3	Align adaptation (01) using spirit level (arrow b).

D41.10-1147-01

4	Mount magnet holder (02) at center of sensor (03) using bolts.

 Sensor attachment (magnet holder (02)) for adaptation:
Article no.: 09935-20

D41.10-1142-02

5	Position magnet holder (02) with sensor (03) on adaptation (01) (arrow c).

 Attach sensor (03) with signal line (03a) so that the signal line (03a) faces in the direction of travel (arrow d).
Otherwise, the measurement will be inaccurate.

Measurement of absolute angle ( A4 on vehicles with 2-piece propeller shaft and  A5 on vehicles with 3-piece propeller shaft)

6	Read off absolute angle ( A4 or  A5) at rear axle housing from display of inclinometer and note down.

D41.10-1148-02

Rework following measurement of absolute angle ( A4 on vehicles with 2-piece propeller shaft and  A5 on vehicles with 3-piece propeller shaft)

7	Remove magnet holder (02) with sensor (03) from adaptation (01).

8	Detach magnet holder (02) from sensor (03).

9	Remove adaptation (01) from joint flange (4) of rear axle housing.

Powiązane dokumenty