The divergence measuring procedure (expansion) depends on the equipment. Refer to the operating manual of the respective equipment to be utilized.
The graphic representation shows the adjustment of the 1st front axle. The adjustment of the 2nd front axle occurs the same way.
1 | Detach the steering rod of the 2nd front axle |
2 | Position the projector (5) with the fastening pin for measuring the expansion on the projector support (4) |
3 | Turn the wheel manually to the left on the rotating plate (6) by angle (a) |
a = 20° |
4 | Place the projector (5) horizontally in vehicle longitudinal direction and tighten the wing screw |
W40.20-0039-01
B40.20-0004-01
5 | Set the scale ring to measure the expansion (33) to zero on the wheel to be measured |
6 | Turn the wheel manually to the right on the rotating plate (6) by angle (a) |
a = 20° |
B40.20-0006-01
B40.20-0005-01
7 | Turn the button (29) until the level is centered |
8 | Read out the indicated value on the scale ring to measure the expansion (33) |
9 | Record the measuring value on the alignment form |
10 | Carry out the expansion measurement of the 2nd front axle wheel the same way |
11 | Attach the steering rod of the 2nd front axle |
W40.20-0041-01