Detach tapered roller bearing from ring gear

Typ ar · temat 35.30 · wersja 0202 · 2020-02-04

Dotyczy: Rear axle 742.824, 743.457, 746.881/882 in model 368.0/1, 384.2/3 Rear axle 742.825 in model 368.0/1, 384.3 Rear axle 746.270 in model 382.1, 634.0 Rear axle 746.271 in model 382.1, 634.0 Rear axle 746.888 in model 368 Rear axle 746.984 in model 384 Rear axle 746.987/988/996/998 in model 958.1 Rear axle 746.999 in model 384.067

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 2 Podwozie › 35 Oś tylna › 35.30 Napęd, wały napędowe — Seria 368 · Seria 382 (modele 1**) · Seria 384 · Seria 634 (modele 0**) · Seria 958 (modele 1**)

EinPAS 17 Zespół przeniesienia napędu/ oś › 17.51 Oś tylna › 17.51.65 Przekładnia osi tylnej/ napęd przelotowy osi — Seria 368 · Seria 382 (modele 1**) · Seria 384 · Seria 634 (modele 0**) · Seria 958 (modele 1**)

Dotyczy też silników/skrzyń biegów: 742 824, 742 825, 743 457, 746 270, 746 271, 746 881, 746 882, 746 888, 746 984, 746 987, 746 988, 746 996, 746 998, 746 999

AR35.30-B-4301-02XB	Detach tapered roller bearing from ring gear
 Caution	Risk of injury caused by scraping or cutting body parts on sharp vehicle parts	Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels.	AS00.00-Z-0017-01A

Rear axle	742.824, 743.457, 746.881/882 in model 368.0/1, 384.2/3
Rear axle	742.825 in model 368.0/1, 384.3
Rear axle	746.270 in model 382.1, 634.0
Rear axle	746.271 in model 382.1, 634.0
Rear axle	746.888 in model 368
Rear axle	746.984 in model 384
Rear axle	746.987/988/996/998 in model 958.1
Rear axle	746.999 in model 384.067

Detach tapered roller bearing from ring gear

317 589 05 63 00

Thrust element

000 589 89 33 00

Puller

The tapered roller bearings of the ring gear and of the differential case must always be replaced together.
Remove

1	Install the  pressure piece on the ring gear (1).

 Only one side of the drift fits in the crown gear.

2	Install the claws of the  puller under the taper roller bearing cage (2).

3	Support the  puller over the  pressure piece and extract the tapered roller bearing (2) from the ring gear (1).

B35.31-0025-02