ar3530b430102ga

Detach tapered roller bearing from ring gear

Typ ar · temat 35.30 · wersja 0104 · 2019-04-20

Dotyczy: Rear axle 741.710 in model 958 Rear axle 746.209/231/233/305 in model 934.2, 938.1, 958 Rear axle 746.213/230 in model 934.2 Rear axle 746.213/230 in model 958.2/4 except code ZC8 (New Final Drive-Top Performance Light) Rear axle 746.218/225 in model 382.1, 634.0 Rear axle 748.590/594 in model 934.2, 958.4

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 2 Podwozie › 35 Oś tylna › 35.30 Napęd, wały napędowe — Seria 382 (modele 1**) · Seria 634 (modele 0**) · Seria 934 (modele 2**) · Seria 938 (modele 1**) · Seria 958

EinPAS 17 Zespół przeniesienia napędu/ oś › 17.51 Oś tylna › 17.51.65 Przekładnia osi tylnej/ napęd przelotowy osi — Seria 382 (modele 1**) · Seria 634 (modele 0**) · Seria 934 (modele 2**) · Seria 938 (modele 1**) · Seria 958

Dotyczy też silników/skrzyń biegów: 741 710, 746 209, 746 213, 746 218, 746 225, 746 230, 746 231, 746 233, 746 305, 748 590, 748 594

AR35.30-B-4301-02GA

Detach tapered roller bearing from ring gear

Caution

Risk of injury caused by scraping or cutting body parts on sharp vehicle parts

Always wear protective gloves when working on or near sharp and non-deburred vehicle parts.
Deburr repair panels.

AS00.00-Z-0017-01A

Rear axle

741.710 in model 958

Rear axle

746.209/231/233/305 in model 934.2, 938.1, 958

Rear axle

746.213/230 in model 934.2

Rear axle

746.213/230 in model 958.2/4

except code ZC8 (New Final Drive-Top Performance Light)

Rear axle

746.218/225 in model 382.1, 634.0

Rear axle

748.590/594 in model 934.2, 958.4

Detach tapered roller bearing from ring gear
Detach tapered roller bearing from ring gear

741 589 05 63 00

Thrust piece

000 589 89 33 00

Puller

Detach tapered roller bearing from ring gear


The differential tapered roller bearings must be replaced as a set.
Remove

1

Use the pressure part as a support on the crown gear (1).


Ensure the correct pressure part position when fitting it on the differential.



2

Install the puller claws on the underside of the taper roller bearing cage (2) .



3

Support the puller over the pressure part and pull the taper roller bearing (2) out of the differential case (1).


B35.31-0025-02

Powiązane dokumenty