204 589 01 43 00
Extraction and insertion tool
652 589 00 33 21
Hand pump
221 589 01 43 00
Extraction and installation tool
001 589 51 33 00
Hollow piston cylinder
652 589 00 33 23
Hydraulic hose (complete)
P35.31-2296-09
01 | Thrust piece | 04 | Spindle | 023 | Hydraulic hose | ||
02 | Counterholder | 07 | Hollow piston cylinder | 4 | Rear axle carrier | ||
03 | Thrust piece | 021 | Hand pump | 10 | Elastomer bearing |
Remove
Required special tools:
Hollow piston cylinder (07) 001 589 51 33 00
Hydraulic hose (023) 652 589 00 33 23
Hand pump (021) 652 589 00 33 21
The following tools are required from the extraction and insertion tool 204 589 01 43 00:
Thrust piece (01) 204 589 01 43 01
Thrust piece (03) 204 589 01 43 03
Spindle (04) 204 589 01 43 04
The following tool is required from the extraction and insertion tool 221 589 01 43 00:
Counterholder (02) 221 589 01 43 02
1 | Mount hollow-piston cylinder (07) with hydraulic hose (023) to hand pump (021). |
2 | Position spindle (04), thrust piece (03), hollow-piston cylinder (07), counterholder (02) and thrust piece (01) on rear axle carrier (4) and elastomer bearing (10). |
3 | Press elastomer bearing (10) out of rear axle carrier (4). |
Carefully screw spindle (04) into thrust piece (01). |
If the hollow-piston cylinder (07) has reached its maximum stroke, release the pressure at the hand pump (021) and screw the spindle (04) further into the thrust piece (01), and then repeat the press-out procedure. |
P35.31-2297-09
03 | Thrust piece | 06 | End stop | 023 | Hydraulic hose | ||
04 | Spindle | 07 | Hollow piston cylinder | 4 | Rear axle carrier | ||
05 | Thrust piece | 021 | Hand pump | 10 | Elastomer bearing |
Install
Required special tools:
Hollow piston cylinder (07) 001 589 51 33 00
Hydraulic hose (023) 652 589 00 33 23
Hand pump (021) 652 589 00 33 21
The following tools are required from the extraction and insertion tool 204 589 01 43 00:
Thrust piece (03) 204 589 01 43 03
Spindle (04) 204 589 01 43 04
End stop (06) 204 589 01 43 06
The following tool is required from the extraction and insertion tool 221 589 01 43 00:
Thrust piece (05) 221 589 01 43 05
4 | Position spindle (04), thrust piece (03), hollow-piston cylinder (07), thrust piece (05), the elastomer bearing (10), and end stop (06) on rear axle carrier (4). |
5 | Press elastomer bearing (10) into rear axle carrier (4). |
Carefully screw spindle (04) into end stop (06). |
If the hollow-piston cylinder (07) has reached its maximum stroke, release the pressure at the hand pump (021) and screw spindle (04) further into the end stop (06), and then repeat the press-in procedure. The shape of the end stop (06) determines the end position of the elastomer bearings (10) in the rear axle carrier (4). |
6 | Remove special tools. |