Modification notes
211 589 00 34 00
Thrust pieces
Extractor and insertion tool
230 589 00 43 00
Repair materials
Number | Designation | Order number |
BR00.45-Z-1028-04A | LU cleaner | Adolf Würth GmbH & Co. KG |
BR00.45-Z-1010-06A | Lubricant, rubber assembly 1 l | A 000 989 03 67 |
P35.10-2211-06
Removing
Always replace front rubber mounts (2) in pairs.
1 Remove washer (1) from rubber mount (2).
2 Insert thrust pieces (01a) in the gap between the rubber mount (2) and rear axle carrier (3)
01a Thrust piece
01b Bow 230 589 00 43 01
01c Sleeve 230 589 00 43 03
01d Thrust piece 230 589 00 43 04
01 E Spindle
1 Washer
2 Rubber bushing
3 Rear axle carrier
3 Fit bracket (01b) onto rear axle carrier (3).
4 Slide sleeve (01c) over thrust pieces (01a) and insert thrust piece (01d) into the sleeve (01c).
5 Press rubber mount (2) out of rear axle carrier (3) by turning in the spindle (01e).
P35.10-2261-05
Install
6 Clean mounting bore in the rear axle carrier (3).
7 Apply a thin coating of rubber assembly fluid to the new rubber mount (2) and in the mounting hole in the rear axle carrier (3).
8 Insert rubber mount (2) in the mounting bore in the rear axle carrier (3).
The cutout (2a) must face towards the vehicle rear.
9 Fit thrust piece (01f) onto rubber mount (2).
01f Thrust piece 211 589 00 34 00
2 Rubber bushing
2a Cutout
3 Rear axle carrier
P35.10-2262-05
10 Insert sleeve (01g) into rear axle carrier (3).
01e Spindle
01f Thrust piece 211 589 00 34 00
01g Sleeve 230 589 00 43 03
1 Washer
2 Rubber bushing
3 Rear axle carrier
11 Press rubber mount (2) into rear axle carrier (3) by turning in the spindle (01e).
Hold the thrust piece (01f) when screwing in the spindle (01e) in order to prevent the rubber mount (2) from twisting.
After tightening the sleeve (01g), spindle (01e) and thrust piece (01f) must remain on the rear axle carrier (3) for 2 minutes to enable the rubber mount (2) to settle.
12 Unscrew spindle (01e) and remove sleeve (01g) and thrust piece (01f).
13 Attach washer (1) to rubber mount (2).