1 | Vent line |
2 | Bleed nozzle |
D35.10-1109-11
| Remove | ||
1 | Warm up vent line (1) on the vent nozzle (2) and then remove line | If the vent nozzle (2) is broken, remove any residual material from the vent line (1) or cut off line just behind the residual material. | |
2 | Remove vent nozzle (2) from the rear axle using pliers | If the vent nozzle (2) is stuck or is broken, drill it out (angular drill with 10.0 mm dia. bit). When doing so, make sure that as few drill shavings as possible enter the axle housing. Keep speed of drill slow. | |
3 | Remove drill shavings from axle housing | If holes were drilled beforehand. | |
| Install | ||
4 | Drive vent nozzle (2) into axle housing up to the stop | Use a 10 mm socket and a short extension as an assembly aid. | |
5 | Blow out vent line (1) with compressed air | ||
6 | Warm up end of vent line (1) and slide onto vent nozzle (2) as far as possible | Check for tight fit. |