Remove/install front stabilizer bar

AR32.35-P-2050MCC

Remove/install front stabilizer bar

20.9.10

 

Remove/install



Notes on self-locking nuts and bolts

AH00.00-N-0001-01A

Danger!

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer.

AS00.00-Z-0010-01A

1

Raise vehicle using the vehicle lift and remove underfloor paneling

Rechargeable drill / screwdriver

gotis://G_58.0_01.1

2

Unscrew nuts (2) on link rods (3)

 Counterhold threaded studs of link rods (3).

 Position the vehicle on its wheels. Only tighten nuts (4) of the clamps (5) when the vehicle is unladen (approx. 75 kg weight on the driver seat and full tank or approx. 20 kg weight in the front passenger area).

 Screwdriver bit

*126589001000

 Tool assortment for stabilizer assembly

*450589001700



*BA32.20-P-1001-02I



*BA32.20-P-1003-02I

3

Unhook link rods (3) from stabilizer bar (1)

4

Unscrew nuts (4), remove clamps (5) and remove the rubber mounts underneath (6) from the stabilizer bar (1)

 The clamps (5) are 2-piece ones.

 Installation: Check rubber bushing (6) and replace if necessary.

The opening of the rubber mounts (6) must point in the direction of travel.
Insert the clamps (5) at a right angle to the stabilizer bar (1). The nuts (4) of clamps (5) are tightened later.

5

Remove stabilizer (1)

 Remove stabilizer (1) carefully, otherwise the radiator may be damaged.

6

Install in the reverse order

Number

Designation

Model
451.3/4

BA32.20-P-1001-02I

Self-locking nut, link rod to stabilizer bar

Nm

58

BA32.20-P-1003-02I

Nut, stabilizer bar to retaining clamp

Nm

95