ar3233m0009a

Remove/install level sensor

Typ ar · temat 32.33 · wersja 0101 · 2010-02-03

Dotyczy: MODEL 905.613 Minibus Sprinter Classic 6 t with wheelbase 4250 mm, with rear air suspension MODEL 905.613 Minibus Sprinter Low Floor 6 t with wheelbase 4250 mm, with rear air suspension

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 2 Podwozie › 32 Zawieszenie › 32.33 Układ poziomowania nadwozia (NR/ENR) — Seria 905 (modele 613)

EinPAS 20 Zawieszenie › 20.20 Układ poziomowania › 20.20.12 Czujnik/ przełącznik/ wiązka przewodów — Seria 905 (modele 613)

AR32.33-M-0009A

Remove/install level sensor

15.1.10

MODEL 905.613
Minibus Sprinter Classic 6 t with wheelbase 4250 mm,
with rear air suspension

MODEL 905.613
Minibus Sprinter Low Floor 6 t with wheelbase 4250 mm,
with rear air suspension

Remove/install level sensor

M32.33-0012-12

1 Level sensor connector

2 Level sensor

3 Actuator rod

Removing

Danger!

Danger to life from lowering vehicle when working between wheels and body. Risk of injury by pinching or crushing when working on the air suspension.

Do not work between wheel and wheel well or in wheel box.

Only carry out check and adjustment operations from underneath the vehicle.

Secure areas with moving vehicle parts against unauthorized access.

AS32.22-Z-0001-01A

1

Detach level sensor connector (1)

2

Remove level sensor operating lever (2)

AR32.33-M-0010A

3

Remove level sensor (2)

Install

2

Install level sensor (2)

5

Screw operating lever onto level sensor (2)

AR32.33-M-0010A

6

Connect level sensor connector (1)

7

Connect STAR DIAGNOSIS

Diagnostic socket for electronic level control on driver side seat frame.

8

Select actual value group for vehicle level in STAR DIAGNOSIS

Remove operating lever, turn lever fastening on level sensor (2) through 180° and mount operating lever.

9

Move operating lever down and note corresponding actual value in STAR DIAGNOSIS

The actual value must rise.

If the actual value drops:

Remove operating lever, turn lever fastening on level sensor (2) through 180° and mount operating lever.

10

Screw operating lever onto actuator rod (3)

AR32.33-M-0010A

11

Calibrate electronic level control (ENR) control unit

AR32.33-M-0004A

12

Delete ENR fault memory

Perform using STAR DIAGNOSIS.

If the calibration is performed correctly, the indicator lamps for "ENR" and "Driving level" go out, and the vehicle is set to driving level.

Powiązane dokumenty