Removing and installing rotary shaft seal on left PTO

AR27.40-S-0100A

29.11.95

ENGINE 111, 601.970 in MODEL 638 with CODE (G40) Automatic transmission

S27.40-2000-06

1 Output flange

2 Safety ring

3 Radial retainer

 	Removing and installing
1	Drain the oil from the transmission		AP27.00-D-2701A
2	Remove the primary shaft in the output flange (1)		AR33.30-S-6500M
3	Remove the output flange (1) with a puller	  Installation: Fit the gearing in the output flange (1) into the gearing of the secondary shaft of the transmission. Fit the output flange (1) with the aid of a rubber hammer  Installation: Pay attention not to damage the stopper lip of the radial retainer (3). The safety ring (2) must fit safely into the secondary shaft of the transmission.	*638589013300
4	Remove the safety ring (2) from the output flange (1)	 Installation: Replace the safety ring (2)
5	Thoroughly clean the area around the radial retainer (3)	 Risk of damage due to dirt entering the transmission  Use a fluff-free cloth
6	Remove the radial retainer (3)	 Installation: Install the radial retainer (3) with the aid of a drift punch
			*638589071500
		 Installation: Pay attention to the correct seating and to the even installation depth of the radial retainer (3)
7	Installation in reverse order

638 589 07 15 00

638 589 01 33 00

Puller

Drift punch