Adjusting the position changeover switch in the transmission shaft

AR27.19-S-0310A

Adjusting the position changeover switch in the transmission shaft

10.1.96

Adjusting

1

Select position “N” in the transmission

2

Remove the position switch (B73)

Transmission installed

AR27.19-S-0300A

Transmission removed

AR27.19-S-0300B

3

Slacken the Torx screws (1)



*WH58.30-Z-1049-06A



*WH58.30-Z-1048-06A

4

With transmission in position “N”, place the adjustment gauge (3.1) on the gear selector assembly and secure it.


 The adjustment gauge (3.1) can only be placed in one position on the gear selector assembly

*WH58.30-Z-1010-12A

5

Move the adjustment plate (2) until the set pin (3.2) permits it to be inserted through the adjustment gauge (3.1) and the hole (arrow) of the adjustment plate (2)



*WH58.30-Z-1010-12A

6

Tighten the Torx screws (1)

 Seal the heads of the combined screws (1) with sealing wax



*BA27.19-N-1004-02A



*WH58.30-Z-1049-06A



*WH58.30-Z-1048-06A

7

Remove the adjustment gauge (3.1) and the set pin (3.2)



*WH58.30-Z-1010-12A

8

Install the position switch (B73)

Transmission installed

AR27.19-S-0300A

Transmission removed

AR27.19-S-0300B

9

Check the operation of the gear shifts

 Do a trial drive, and if appropriate,  repeat the adjustment operation

Number

Designation

Model 638 with engines 111, 601.970, 611.980

Model 638 with engine 104.900

BA27.19-N-1004-02A

Screw of adjustment plate (position switch) to transmission housing

Nm

10

–

Number

Designation

WH58.30-Z-1048-06A

Bit holder, 1/4"

WH58.30-Z-1049-06A

Internal torx-bit with bore T27

WH58.30-Z-1010-12A

Adjusting gauge of position switch for automatic transmission T0,

GLC-Germersheim

Q5X46 001 454