ar2719s0022cc

Remove/install rpm sensor on dual-clutch transmission

Typ ar · temat 27.19 · wersja 0100 · 2020-09-08

Dotyczy: Transmission 700.740 in model 415 with engine 200 B109 Rpm sensor 2, transmission input shaft

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 2 Podwozie › 27 Automatyczna skrzynia biegów › 27.19 Układ elektryczny skrzyni biegów — Seria 415

EinPAS 17 Zespół przeniesienia napędu/ oś › 17.20 Skrzynia biegów › 17.20.12 Czujnik/ przełącznik/ wiązka przewodów — Seria 415

Dotyczy też silników/skrzyń biegów: 200 ***, 700 740

AR27.19-S-0022CC

Remove/install rpm sensor on dual-clutch transmission

25.08.2020

Transmission

700.740 in model 415 with engine 200

B109 Rpm sensor 2, transmission input shaft

Remove/install rpm sensor on dual-clutch transmission

S27.19-4533-09

Shown on removed dual-clutch transmission

1

Electrical connectors

6

Spacer

2

Bolts

B109

Rpm sensor 2, transmission input shaft

Danger

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

Caution

Risk of injury to skin and eyes due to handling of transmission oil. Health risk caused by swallowing transmission oil

Wear protective gloves, protective clothing and safety glasses.
Do not pour transmission oil into beverage bottles.

AS00.40-Z-0001-01A

Topical note

Notes on avoiding damage through contamination and foreign objects

AH00.00-P-5000-01A

Topical note

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

Remove/install

1

Raise vehicle.

AR00.60-S-1000C

2

Release and disconnect electrical connector (1) from transmission input shaft rotational speed sensor 2 (B109).

3

Remove screw (2) from transmission input shaft rotational speed sensor 2 (B109).

Bolt, rpm sensor to transmission housing

*BA27.19-N-1001-02CV

4

Remove transmission input shaft rotational speed sensor 2 (B109) with spacer (6).

Installation:
The transmission input shaft rotational speed sensor 2 (B109) must be installed with spacer (6).
Otherwise, transmission input shaft rotational speed sensor 2 (B109) will be damaged.

Installation: Replace seal.

Transmission input shaft rpm sensor spacer

*BE27.19-N-1002-01C

5

Install in the reverse order.

Automatic transmission rpm sensor

Number

Designation

Transmission 700.740 in model 415

BE27.19-N-1002-01C

Transmission input shaft rpm sensor spacer

mm

2

Electrical components

Number

Designation

Transmission 700.740 in model 415

BA27.19-N-1001-02CV

Bolt, rpm sensor to transmission housing

Nm

9

Powiązane dokumenty