ar2719d1718tsf

Remove/install automatic transmission control unit

Typ ar · temat 27.19 · wersja 0100 · 2018-08-21

Dotyczy: Model 910 with transmission 700.75

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 2 Podwozie › 27 Automatyczna skrzynia biegów › 27.19 Układ elektryczny skrzyni biegów — Seria 910

EinPAS 17 Zespół przeniesienia napędu/ oś › 17.20 Skrzynia biegów › 17.20.11 Moduł sterujący/ przekaźnik — Seria 910

Dotyczy też silników/skrzyń biegów: 700 75*

AR27.19-D-1718TSF

Remove/install automatic transmission control unit

13.08.2018

Model

910 with transmission 700.75

Remove/install automatic transmission control unit

D27.19-1171-08

1

Control unit

4

Screw

7

Electrical wiring harness

2

Electrical connector

5

Screw

3

Bracket

6

Bolts

Danger

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

Topical note

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

Remove/install

1

Connect vehicle diagnosis system and transfer data from control unit (1) to vehicle diagnosis system.

If the control unit (1) is being replaced.

Connect/disconnect diagnostic unit

AD00.00-D-2000-06TS

Installation: Transfer saved data from vehicle diagnosis system to new control unit (1).

2

Switch off ignition and store transmitter key outside of transmitter range (min. 2 m).

3

Raise vehicle.

AR00.60-D-1000-04TS

Topical note

Special instructions for lifting and supporting vehicle

AH00.60-N-0100-01TS

4

Remove lower engine compartment paneling.

If installed.

AR61.20-D-1105TS

5

Unscrew bolt (4).

Bolt, holder of control unit to automatic transmission

*BA27.10-N-1007-06TSF

6

Lower vehicle.

7

Open hood.

8

Release and disconnect electrical connector (2) from control unit (1).

9

Detach electrical wiring harness (7) from bracket (3).

10

Remove control unit (1) with bracket (3).

To do this, remove screws (5) and remove bracket (3) with control unit (1).

Bolt, holder of control unit to automatic transmission

*BA27.10-N-1007-06TSF

11

Detach control unit (1) from bracket (3).

If the control unit (1) is being replaced.

To do so, remove the bolts (6).

Bolt, control unit to bracket

*BA27.10-N-1006-06TSF

12

Install in the reverse order.

Automatic transmission

Number

Designation

Transmission 700.750 in model 910

BA27.10-N-1006-06TSF

Bolt, control unit to bracket

Nm

24

Automatic transmission

Number

Designation

Transmission 700.750 in model 910

BA27.10-N-1007-06TSF

Bolt, holder of control unit to automatic transmission

Nm

24

Powiązane dokumenty