Remove/install oil pump from transmission housing

AR27.10-D-0400-02TSC

Remove/install oil pump from transmission housing

 Caution

Risk of injury to skin and eyes due to handling of transmission oil. Health risk caused by swallowing transmission oil

Wear protective gloves, protective clothing and safety glasses.
Do not pour transmission oil into beverage bottles.

AS00.40-Z-0001-01A

 Caution

Risk of injury caused by scraping or cutting body parts on sharp vehicle parts

Always wear protective gloves when working on or near sharp and non-deburred vehicle parts.
Deburr repair panels.

AS00.00-Z-0017-01A

Transmission

725.0 in model 907

01

Bridge

02

Clamping pliers

03

Spindle

04

Spring pin

05

Thrust piece

07

Upright M8

08

Upright M6

11

Removal and installation tool

12

Knurled nut

1

Attach upright M8 (07) and upright M6 (08) of  removal and installation tool (11) as shown.

2

Insert thrust piece (05) into clamping pliers (02) and secure using spring pin (04).

3

Place bridge (01) and secure with knurled nut (12).

4

Place thrust piece (05) on the oil pump (10) by turning it at the spindle (03).

 Make sure that the thrust piece (05) is correctly seated.
Otherwise the oil pump (10) can be damaged.

5

Press oil pump (10) downward up to end stop by turning it at the spindle (03).

6

Remove retaining ring (13).

7

Unlock spring pin (04) and remove thrust piece (05) out of clamping pliers (02).

8

Place clamping pliers (02) onto drive of oil pump (10) and secure with spring pin (04).

9

Pull oil pump (10) out of torque converter housing (1) by turning it at the spindle (03).

10

Remove bridge (01) with oil pump (10).

11

Unlock clamping sleeve (04) and pull out oil pump (10) from compression spring.

12

Insert oil pump (10).

 Apply oil to O-rings of oil pump (10).

 The markings (arrow) on the oil pump (10) and on the torque converter housing (1) must face towards each other when being assembled.

13

Insert thrust piece (05) into clamping pliers (02) and secure using spring pin (04).

14

Place bridge (01) and secure with knurled nut (12).

15

Place thrust piece (05) on the oil pump (10) by turning it at the spindle (03).

 Make sure that the thrust piece (05) is correctly seated.
Otherwise the oil pump (10) can be damaged.

16

Press oil pump (10) downward up to end stop by turning it at the spindle (03).

17

Install retaining ring (13).

18

Remove thrust piece (05) from the oil pump (10) by turning it at the spindle (03).

19

 Remove removal and installation tool (11).