W26.18-1020-09
1 | Range group cylinder | 4 | Sealing ring | 7 | Shift piston | ||
2 | O-ring | 5 | Electrical connector | B504 | Range group travel sensor | ||
3 | O-ring | 6 | O-ring |
5 | Electrical connector |
21 | Compressed air line (range group position "Low-speed)) |
22 | Compressed air line (range group position "High-speed) |
23 | Compressed air connections (power takeoff) |
B504 | Range group travel sensor |
W26.18-1019-06
Notes on compressed air connection systems | |||
| Remove | ||
1 | Switch off ignition. | ||
2 | Disconnect electrical connector (5) from range group travel sensor (B504). | ||
3 | Detach compressed-air lines (21, 22) from range group cylinder (1). | ||
4 | Detach compressed-air lines from compressed-air connections (23) of range group cylinder (1). | Only on transmission with power take-off. | |
5 | Admit compressed air to compressed-air connection for "Low-speed" range group position and switch shift piston (7) of range group to "Low-speed" position. | ||
6 | Remove range group cylinder (1). | ||
7 | Remove O-rings (2, 3) from range group cylinder (1). | ||
8 | Remove O-ring (6) on transmission. | ||
9 | Remove sealing ring (4) from shift piston (7). | ||
| Install | ||
10 | Install new sealing ring (4) on shift piston (7) and fill cavity between the two sealing lips of sealing ring (4) with lubricant. | Klueber Polylub GLY 801 grease | |
11 | Coat new O-ring (6) with lubricant and insert into transmission. | Klueber Polylub GLY 801 grease | |
12 | Coat new O-rings (2, 3) with lubricant and install on range group cylinder (1). | Slide on O-ring (2) until it abuts. | |
Klueber Polylub GLY 801 grease | |||
13 | Install range group cylinder (1). | Range group cylinder to transmission | |
14 | Attach compressed-air lines (21, 22) to range group cylinder (1). | ||
15 | Attach compressed-air lines to compressed-air connection (23) of range group cylinder (1). | Only on transmission with power take-off. | |
16 | Connect electrical connector (5) to range group travel sensor (B504). | ||
17 | Connect vehicle diagnosis system and switch on ignition. | Only if a new range group cylinder (1) was installed. | |
See information from body manufacturer. | |||
18 | Teach-in transmission control unit (TCM) (A5) and clutch. | Only if a new range group cylinder (1) was installed. | |
The teach-in process is completely menu-assisted under: | |||
19 | Remove vehicle diagnosis system. | Only if a new range group cylinder (1) was installed. |
Powiązane dokumenty
- ah0018n000101a Wskazówki dotyczące systemów złączy wtykowych przewodów sprężonego powietrza