Remove/install bushing of transmission mounting

AR26.10-S-0030A

11.11.11

ENGINE 111.948 /950 /978 /980, 601.942 /970 in MODEL 638 except CODE (G40) Automatic transmission

S26.10-3002-06

1 Engine retaining device 

2 Left drive shaft

3 Screw

4 Screw

5 Axle longitudinal member part

6 Screw

7 Mount for transmission mounting

8 Puller 

 	Remove/install
1	Detach left front wheel		AR40.10-S-1100A
2	Insert engine holding device (1) and relieve mount of transmission mounting (7) of load	 Detach bracket of power steering pump oil reservoir on lock crossmember.
		Engine support device, engine hoist gotis://A_01_09.0
3	Remove noise encapsulation lower section		AR94.30-S-5300A
4	Detach left drive shaft (2) at output flange		*BA33.30-N-1001-01A
			*BA33.30-N-1001-07B
5	Detach left transverse control arm on axle longitudinal member part (5) from axle/engine subframe and on kingpin and release threaded connection of rubber mount (3) from transverse control arm (7)	 Resurface transverse control arm, do not damage dust caps. The transverse control arm (7) remains fitted to the axle/engine subframe.	AR33.20-S-1452M
6	Unscrew bolt (6) on mount of transmission mounting (7)	 The transmission must be raised with the engine holding device until the bolt (6) can be pulled out and inserted without mismatch.
		 Engine 111	*BA26.00-N-1001-01A
		 Engine 601, 611	*BA26.00-N-1001-01C
7	Detach axle longitudinal member part (5) on axle/engine subframe		*BA31.35-N-1005-01A
8	Remove mount of transmission mounting (7) using puller (8)	 Installation: Drive in mount of transmission mounting (7) using a suitable tool. The markings on the mount (arrow) and transmission housing (arrow) must match.
			*638589033300
9	Install in the reverse order

 Manual transmission general

Number	Designation		Model 638 with engine 111.948/ 950/978/980 without code G40


BA26.00-N-1001-01A	Transmission bearing to axle/engine subframe	Nm	104

 Manual transmission general

Number	Designation		Model 638 with engine 601.942/970 and 611.980 without code G40


BA26.00-N-1001-01C	Transmission bearing to axle/engine subframe	Nm	104

 Axle/engine subframe

Number	Designation		Model 638.014/034/ 064/074/094/ 114/134/164/ 174/194/214/ 234/244/274/294 without code G40


BA31.35-N-1005-01A	Longitudinal axle member to axle/engine subframe	Nm	140

 Front axle drive

Number	Designation		Model 638 with engine 601.942/970


BA33.30-N-1001-01A	Bolt, left drive shaft to output flange	Nm	62

 Input shaft

Number	Designation		Model 638 with Engine 111.948/ 950/978/ 980


BA33.30-N-1001-07B	Bolt, left drive shaft to output flange	Nm	62

638 589 03 33 00

Puller