ar1840d5116tsv

Remove/install engine oil fill level sensor

Typ ar · temat 18.40 · wersja 0100 · 2018-04-19

Dotyczy: Engine 642 in model 907

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 1 Silnik › 18 Układ smarowania silnika, układ chłodzenia oleju › 18.40 Czujnik poziomu oleju, czujnik ciśnienia oleju — Seria 907

EinPAS 15 Silnik › 15.20 Układ smarowania silnika › 15.20.12 Czujnik/ przełącznik/ wiązka przewodów — Seria 907

Dotyczy też silników/skrzyń biegów: 642 ***

AR18.40-D-5116TSV

Remove/install engine oil fill level sensor

01.03.2018

Engine

642 in model 907

Remove/install engine oil fill level sensor

1

Electrical connector

2

Bolts

3

Fill level sensor

D18.40-1130-11

Danger

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

Caution

Risk of injury to skin and eyes due to handling of engine oil. Risk of poisoning caused by swallowing engine oil

Wear protective gloves, protective clothing and safety glasses.
Do not fill engine oil into beverage containers.

AS18.00-Z-0001-01A

Remove/install

1

Raise vehicle

AR00.60-D-1000-04TS

Topical note

Special instructions for lifting and supporting vehicle

AH00.60-N-0100-01TS

2

Remove lower engine compartment paneling

If installed.

AR61.20-D-1105TS

Installation: Only install engine compartment paneling after leaktightness test.

3

Drain engine oil

Engine oil and oil filter change

AP18.00-D-0101TS

4

Disconnect electrical connection (1)

5

Remove fill level sensor (3)

To do this, remove screws (2).

Installation: Check sealing ring for damage.

Screw/bolt, fill level sensor to oil pan bottom section

*BA18.40-N-1001-03TS

If sealing ring is damaged,

Replace sealing ring.

6

Install in the reverse order

Check

Warning

Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.

Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts.

AS00.00-Z-0005-01A

7

Check for leak tightness with engine running

Visual inspection only.

Fill level sensor, temperature sensor

Number

Designation

Engine 642 in model 907

BA18.40-N-1001-03TS

Screw/bolt, fill level sensor to oil pan bottom section

Nm

11

Powiązane dokumenty