ar1540p5760gl

Remove/install regulator of generator

Typ ar · temat 15.40 · wersja 0102 · 2012-02-22

Dotyczy: ENGINE 612.966 in MODEL 461.302 /331 /332 /342 /345 Additional alternator 24 V

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 1 Silnik › 15 Instalacja elektryczna silnika › 15.40 Alternator — Seria 461 (modele 302, 331, 332, 342, 345)

EinPAS 25 Instalacja elektryczna/sieć wymiany danych/wielofunkcyjne › 25.20 Sieć pojazdu › 25.20.30 Alternator — Seria 461 (modele 302, 331, 332, 342, 345)

Dotyczy też silników/skrzyń biegów: 612 966

AR15.40-P-5760GL

Remove/install regulator of generator

14.2.12

ENGINE 612.966 in MODEL 461.302 /331 /332 /342 /345
Additional alternator 24 V

Remove/install regulator of generator

P15.40-2196-08

1 Vent hose

2 Cover

3 Rubber seal

4 Terminal 61

5 Terminal 30 (B+)

6 Screw

7 Controller

G2/1 Alternator 24V

Remove/install regulator of generator

P15.40-2281-01

2 Cover

3 Rubber seal

Remove/install

Danger!

Risk of explosion caused by escaping oxyhydrogen gas. Risk of injury caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte (contains diluted sulfuric acid) or metal spatter due to short circuit. Risk of burn injuries caused by short circuit. Risk of poisoning caused by swallowing battery electrolyte (contains diluted sulfuric acid) or absorption of lead over the skin or orifices

No fire, sparks, open flames or smoking.

Wear acid-resistant gloves and clothing and safety glasses with side guards.

Do not place any conductive objects on the battery and avoid any short circuit from battery positive to ground.

Only fill liquid battery electrolyte (diluted sulfuric acid) into suitable and appropriately marked containers.

AS54.10-Z-0001-01A

1

Disconnect ground cable from battery

The vehicle has a 12 V and 24 V on-board electrical system. Disconnect both ground lines for safety reasons.

AR54.10-P-0003GL

Notes on battery

All models

AH54.10-P-0001-01A

Danger!

Risk of death cased by vehicle slipping or toppling off of the lifting platform.

Align vehicle between the columns of the hydraulic hoist and position the four support plates below the hoist support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

2

Lift/jack up vehicle

AR00.60-P-1000G

3

Remove underride guard

4

Remove air admission hose (1) on cover (2)

5

Remove cover (2)

Installation: ensure correct seating of the rubber seal (3) in the cover (2) to prevent ingress of water.

6

Unscrew bolts (6)

7

Take out regulator (7)

8

Install in the reverse order

Powiązane dokumenty