Remove/install Hall sensor of camshaft

AR15.10-P-1999MFE

Remove/install Hall sensor of camshaft

20.08.2019

Engine

608 in model 118, 177, 247

Shown on model 177

1

Electrical connector

2

Screw

B6/1

Camshaft Hall sensor

 Warning

Risk of injury. Skin or eye injuries may result when handling hot or glowing objects.

Wear protective gloves, protective clothing and safety glasses, if necessary.

AS00.00-Z-0002-01A

 Caution

Risk of injury to skin and eyes due to handling of engine oil. Risk of poisoning caused by swallowing engine oil

Wear protective gloves, protective clothing and safety glasses.
Do not fill engine oil into beverage containers.

AS18.00-Z-0001-01A

 Caution

Risk of injury caused by scraping or cutting body parts on sharp vehicle parts

Always wear protective gloves when working on or near sharp and non-deburred vehicle parts.
Deburr repair panels.

AS00.00-Z-0017-01A

Topical note

Notes on avoiding damage through contamination and foreign objects

AH00.00-P-5000-01A

Topical note

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

Notes on safety-relevant components

AH00.00-Z-0019-01A

 

Remove/install

1

Remove cover of cylinder head cover.

AR01.20-P-5015MFE

 Installation: Only install upper engine cover after the leak test.

2

Release and disconnect electrical connector (1) from camshaft Hall sensor (B6/1).

3

Remove screw (2).

 Camshaft position sensor on cylinder head cover

*BA07.04-P-1010-02C

4

Remove camshaft Hall sensor (B6/1).

 Installation: Replace sealing ring.

5

Seal exposed opening with suitable stop plug.

 Record plug

*129589009100

6

Install in the reverse order.

 Warning

Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.

Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts.

AS00.00-Z-0005-01A

7

Perform engine test run. While doing so, check engine for proper operation and leak tightness.

8

Install upper engine cover.



AP01.10-P-2405-01B

 Sensors

Number

Designation

Engine 608

BA07.04-P-1010-02C

Camshaft position sensor on cylinder head cover

Nm

10