D13.30-0002-08
Shown with engine removed
1 Compressor
2 Screw/bolt
3 Banjo bolt
4 Sealing rings
9 Fitting
10 Compressed-air line
11 Air intake line
12 O-ring
13 Drive gear
5 Coolant line (return flow)
6 Banjo bolt
7 Sealing ring
8 Coolant line (feed line)
Modification notes
| Remove/install | ||
1 | Drain coolant | ||
2 | Remove MR/PLD control unit | ||
3 | Remove intake air line (11) on compressor (1) and expose | ||
4 | Remove compressed air line (10) from fitting (9) and expose | For carbonization of compressed air line (10) also check compressed air lines between compressor (1), compressed air drier and four-circuit protection valve; replace coked components if necessary. | |
5 | Detach coolant lines (5, 8) at compressor (1) | | |
6 | Remove power steering pump (1) from compressor and lay down to one side with connected hydraulic lines | ||
| |||
Long-life grease | |||
7 | Detach compressor (1) at crankcase | Installation: If the compressor (1) cannot be inserted in the crankcase, turn crankshaft using turning device or drive wheel (13) at compressor (1). | |
| |||
| |||
8 | Take drive gear (13) off compressor (1) | Only if drive wheel (13) of compressor (1) was replaced. | |
9 | Install in the reverse order |
Compressor (compressed air system)
Number | Designation | Engines | ||
BA13.30-N-1004-01A | Banjo bolt, coolant line to compressor | Nm | 40 | |
BA13.30-N-1006-01A | Screw/bolt, compressor to crankcase | Nm | 50 | |
Power steering pump
Number | Designation | Steering | |
BA46.30-N-1001-01B | Screw/bolt, power steering pump to compressor | Nm | 40 |
Cranking device
904 589 04 63 00
Repair materials
Number | Designation | Order number |
BR00.45-Z-1001-06A | Long-life grease | A 000 989 63 51 11 |