D09.00-0007-09
1 | Air intake hose | 3 | Oil cover | |
2 | Adapter | 4 | Oil dipstick |
| Remove | ||
1 | Remove air intake hose (1) from air filter housing | To do this loosen clamp. | |
| Check | ||
2 | Check air intake hose (1) | Depending on findings | |
| |||
Replace air intake hose (1). | |||
3 | Attach adapter (2) to air intake hose (1) | Fasten clamp correctly. | |
4 | Prepare leaktightness tester and calibrate | ||
| 000 588 18 21 00 Leak tester | ||
Adjust test parameter ".040". Pay attention to manufacturer's operating instructions. | |||
5 | Switch on leaktightness tester | Pay attention to manufacturer's operating instructions. | |
6 | Remove oil cover (3) | In order to ensure correct checking, sufficient smoke must escape for an opened filler opening. | |
If the smoke coming out is low | |||
| |||
Check leaktightness tester and rectify fault | |||
7 | Installl oil cover (3) | ||
8 | Check oil dipstick (4) for firm seating in the guide tube | ||
9 | Start test mode of the leaktightness tester | Pay attention to manufacturer's operating instructions. | |
10 | Read of scale of the leaktightness tester | For read off > ".040" | |
| |||
Leak on the charge air system, the EGR or on the crankcase side | |||
For read off > ".040" | |||
| |||
Charge air system and EGR OK | |||
11 | Check smoke escaping on the assembly parts of the charge air system and the EGR | Only if leak on the charge air system, the EGR or on the crankcase side | |
For smoke escaping | |||
| |||
Remove leak | |||
12 | Switch off leaktightness tester | ||
13 | Remove leaktightness tester and adapter (2) | ||
| 000 588 18 21 00 Leak tester | ||
Pay attention to manufacturer's operating instructions. | |||
| Install | ||
14 | Attach air intake hose (1) to air filter housing | Check clamp; replace if necessary. |