1 | Park pawl sensor |
2 | Electrical connector |
3 | Screw |
4 | Sealing ring |
5 | Axle drive module |
D08.40-A000-76
Danger | Risk of death when working on component parts and systems with U >= 30 V alternating voltage (AC) or U >= 60 V direct voltage (DC) | Do not touch damaged or defective live component parts and lines or non-insulated electrical connections and lines. | |
Caution | Risk of injury to skin and eyes due to handling of transmission oil. Health risk caused by swallowing transmission oil | Wear protective gloves, protective clothing and safety glasses. | |
Topical note | Notes on avoiding damage through contamination and foreign objects | ||
Topical note | General information on handling vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system | ||
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
| Remove/install | ||
1 | Switch off ignition and store transmitter key outside of transmission range (min. 2 m). | ||
2 | Remove bottom engine compartment paneling. | ||
Installation: Only install lower engine compartment paneling after leak test. | |||
3 | Disconnect electrical connection (2). | ||
4 | Remove bolt (3) . | ||
5 | Remove park pawl sensor (1) from the axle drive module (5). | ||
| Transmission oils (specification 236.24) | ||
Seal off opening. | |||
Installation: Coat sealing ring (4) of the park pawl sensor (1) with transmission oil. | |||
Record plug | |||
| Check | ||
6 | Check sealing ring (4) of the park pawl sensor (1) for damage. | If damage is present: | |
| |||
replace park pawl sensor (1). | |||
7 | Install in the reverse order. | ||
8 | teach in park pawl sensor (1) with diagnostic device. | When replacing park pawl sensor (1). | |
| Connect/disconnect diagnostic unit | ||
| Check | ||
9 | Perform leak test in the area of the park pawl sensor (1). | Visual inspection only. |
129 589 00 91 00
Record plug
Powiązane dokumenty
- ad0000d200006ts
- ah0000p500001a Wskazówki dotyczące zapobiegania uszkodzeniom na skutek zabrudzeń i ciał obcych
- ah0000z030001a Ogólne wskazówki dotyczące pojazdów z instalacją wysokiego napięcia i/lub akumulatorem litowo-jonowym i/lub gazowym systemem napędu oraz osobistego wyposażenia ochronnego
- ah5400p000101a Wskazówki dotyczące zapobiegania uszkodzeniom elementów elektronicznych na skutek rozładowania potencjału elektrostatycznego
- ar6120d1105ts
- as0000z003501a Zagrożenie życia podczas prac przy elementach i systemach U >=30 V napięcie zmienne (AC) bądź U >=60 V napięcie zmienne
- as0040z000101a Niebezpieczeństwo obrażeń skóry i oczu podczas kontaktu z olejem przekładniowym. Zagrożenie dla zdrowia na skutek połknięcia oleju przekładniowego
- bb0040p023624a