S07.52-1017-06
1 Nut
2 Vacuum hose
3 Reference resistor
A13 PEC control module
A13.1 Plug connection (side of vehicle)
A13.2 Plug connection (engine side)
A13.3 Plug connection (position sensor)
| Removing, installing | ||
1 | Disconnect ground cable at the battery | ||
2 | Remove right headlamp unit together with turn signal lights | ||
3 | Take off protective cap at PEC control module (A13) | ||
4 | Unplug electrical connections (A13.1, A13.2 and A13.3) | ||
5 | Detach vacuum hose (2) at PEC control module (A13) | ||
6 | Unscrew nut (1) | Replace self-locking nut. | |
7 | Remove PEC control module (A13) | If PEC control module (A13) is replaced, use existing reference resistor (3). | |
8 | Install in the reverse order | ||
| Inspecting | ||
9 | Read fault memory of PEC control module, erase if necessary | See Diagnosis Manual Engine |