1 | Electric connector |
2 | Screw |
3 | Electric connector |
4 | Electric wiring harness |
5 | Screw |
6 | Support |
7 | Engine management control unit (MCM) |
8 | Dumping rubbers |
B07.08-0002-05
| Remove | ||
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
1 | Connect the Star Diagnosis, start the Xentry, and perform the quick test | Only if the engine module (MCM) (7) is replaced. | |
2.1 | Select the item "control unit change" and follow the instructions | When the engine management control unit (MCM) (7) is replaced | |
2.2 | Turn off ignition | When the engine management control unit (MCM) (7) is not replaced | |
3 | Remove the acoustic encapsulation | ||
4 | Disconnect the electric connector (1) in the engine management control unit (MCM) (7) | ||
5 | Loosen the screw (2) and disconnect the electric connector (3) in the engine management control unit (MCM) (7) | ||
6 | Let the wiring harness (4) uncovered in the engine management control unit (MCM) (7) | ||
7 | Remove the bolts (5) | ||
8 | Remove the engine management control unit (MCM) (7) with the rubber bumper (8) | ||
9 | Remove the bracket (6) from the engine management control unit (MCM) (7) | Only if the engine management control unit (MCM) (7) is replaced. | |
| Install | ||
10 | Install the bracket (6) in the engine management control unit (MCM) (7) | Only if a new engine management control unit (MCM) (7) is installed. | |
Screw of oil suction line/harness holder on engine control unit control unit (MCM) | |||
11 | Install the engine management control unit (MCM) (7) with the rubber bumper (8) | Observe the assembly position of the rubber bumper (8). | |
12 | Tighten the screws (5) | Engine regulation control unit screw (MCM) on fuel filter module | |
13 | Fix the wiring harness (4) in the engine management control unit (MCM) (7) | ||
14 | Connect the electric connector (3) in the engine management control unit (MCM) (7) and screw up the screw (2) | Screw of electric connection on engine management control unit (MCM) | |
15 | Connect the electric connector (1) in the engine management control unit (MCM) (7) | ||
16 | Install the acoustic encapsulation | ||
17 | Follow the instructions for "control unit change" | Only if the engine management control unit (MCM) (7) is replaced. | |
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
18 | Start the engine and perform the engine test cycle | ||
19 | Finish the Xentry and remove the Star Diagnosis | Only if the engine management control unit (MCM) (7) is replaced. |
Powiązane dokumenty
- ah5400p000101a Wskazówki dotyczące zapobiegania uszkodzeniom elementów elektronicznych na skutek rozładowania potencjału elektrostatycznego
- as0000z000501a Niebezpieczeństwo wypadku na skutek samoczynnego ruszenia przy pracującym silniku. Niebezpieczeństwo obrażeń na skutek zmiażdżenia lub poparzenia przy wykonywaniu czynności podczas rozruchu lub przy pracującym silniku.