602 589 00 39 00
Thrust piece
Riveting tool
Case
Guide
602 589 00 98 00
602 589 03 63 00
640 589 01 63 00
Hold-down device
640 589 01 40 00
P05.10-2327-11
Proceed with the attached hold-down device (4).
1 Connect the ends of the new timing chain (1) with a new riveted link (7).
Insert riveted link (7) from the rear.
P05.10-2328-01
2 Place guide (8) with digit F6 into the rivet press tool (9) and fix in place.
P05.10-2329-01
3 Insert thrust piece (10) with digit D8 into the rivet press tool (9).
P05.10-2330-01
4 Insert new outer plate (11) into the thrust piece (10).
The outer plate (11) is held by a magnet.
P05.10-2331-01
5 Position riveting tool (9) so that the spacer webs (arrow) are making contact.
6 Tighten spindle at riveting tool (9) until a firm resistance is felt.
When turning the spindle, ensure that the pins of the riveted link move into the holes of the outer plate.
7 Take off rivet press tool (9).
P05.10-2332-01
8 Turn thrust piece (10) with the digit D8 on the riveted link (arrow).
P05.10-2333-01
9 Position riveting tool (9) exactly above the middle of the pins (arrow).
10 Tighten spindle at the riveting tool (9) fully.
Tightening torque of the spindle: reference value of around 30-35 Nm.
11 Rivet the second pin in the same way.
12 Take off rivet press tool (9).
D18.10-1014-01
13 Inspect riveting (arrows), re-rivet if necessary.
14 Remove the rag from the chain slot and the cylinder head.