Removing and installing flywheel/drive plate

AR03.30-S-8001B

22.6.95

ENGINE 601 in MODEL 638

S03.30-2004-09

1 Torx bolt

2 Washer (code G40)

3 Straight pin

4 Flywheel

5 Drive plate (code G40)

6 Tommy bar

7  Retaining lock

 	Removing, installing
1.1	Remove manual transmission		AR26.10-S-0020A
1.2	Remove automatic transmission	With automatic transmission (code G40)	AR27.10-S-0500B
2	Remove clutch		AR25.10-S-0050A
3	Install retaining lock (7) for crankshaft/starter ring gear		AR03.30-S-5000B
4	Unscrew torx bolts (1)		*BA03.30-N-1002-01B
			*000589011000
		Installation: Replace torx bolts (1). If no torque angle wrench is available, the torx bolts (1) can be torqued further by the specified angle in a single operation using a wrench and tommy bar (6).  Do not use a flexi-torque wrench for tightening to torquing angles in order to avoid any angle errors
5	Remove flywheel (4) on vehicles with manual transmission, or drive plate (5) and washers (2) on vehicles with automatic transmission	 The straight pin (3) centers the flywheel (4) or drive plate (5). The flywheel (4) and drive plate (5) are individually balanced and can be installed without further balancing
6	Install in the reverse order

 Flywheel, drive plate, vibration damper, starter ring gear

Number	Designation			Engine 601.942/ 970


BA03.30-N-1002-01B	Bolt, flywheel/drive plate to crankshaft	1st stage	Nm	45
		2nd stage	°	90

000 589 01 10 00

Internal torx set