P03.30-2135-04
1 Flywheel
2 Bolts
| Remove/install | ||
1 | Remove clutch | ||
2 | Unscrew bolts (2) at flywheel (1) | Install new self-locking bolts (2). | |
Installation: To exclude any possibility of offset angle errors, a bending rod torquing angle wrench must not be used for tightening. If no torquing angle wrench is available, the bolts (2) can be torqued further by the specified angle in a single operation using a wrench and Tommy bar. | |||
| |||
3 | Detach retaining lock for engine | ||
| |||
4 | Remove flywheel (1) from crankshaft | Observe installation position of flywheel (1). | |
Installation: Check flywheel (1) for wear; replace if necessary. | |||
5 | Install in the reverse order |
Flywheel, driven plate, vibration damper, starter ring gear
Number | Designation | Engine | ||
BA03.30-P-1002-01P | Bolt, flywheel to crankshaft | Stage 1 | Nm | 20 |
Stage 2 | ° | 90 | ||
Retaining lock
451 589 01 40 00