AR03.30-P-8002FG | Removing/installing the flywheel | 28.9.04 |
ENGINE 639.939 in MODEL 454.0 with TRANSMISSIONS 717.473 /475
1 Flywheel
2 Retaining lock
3 Bolts
P03.30-2104-03
| Removing/installing | ||
1 | Remove clutch | ||
2 | Remove screws (3) | Installation: Check flywheel (1), replace if necessary. Replace bolts (3) and tighten crosswise. Do not use a flexi-torque wrench for tightening to angle degrees in order to avoid any angle errors. | |
| |||
3 | Remove flywheel (1) from the crankshaft | Installation: Observe cylindrical pin on flywheel (1). The installation position is fixed by the cylindrical pin on the flywheel (1) and the aligning bore on the crankshaft. | |
4 | Remove retaining lock (2) | Installation: Only mount retaining lock (2) after fitting the flywheel (1). | |
| |||
5 | Install in reverse order |
Flywheel, driven plate, vibration damper, starter ring gear
Number | Designation | Engine | ||
BA03.30-P-1003-01K | Bolt for flywheel on crankshaft | 1st stage | Nm | 45 |
Step 2 | ° | 180 | ||
Retaining lock
454 589 00 40 00