ap8300s8381a

Replace dust filter for heating/ventilation

Typ ap · temat 83.00 · wersja 0100 · 2000-01-27

Dotyczy: MODEL 638.### 2# Right-hand steering only

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 83 Klimatyzacja › 83.00 Informacje ogólne — Seria 638

EinPAS 39 Ogrzewanie/ wentylacja/ chłodzenie › 39.15 Klimatyzacja › 39.15.32 Obudowa/wymiennik ciepła/parownik/filtr — Seria 638

AP83.00-S-8381A

Replace dust filter for heating/ventilation

1.12.99

MODEL 638.### 2#
Right-hand steering only

Replace dust filter for heating/ventilation

S83.00-4001-06

1 Cover

2 Dust filter

3 Bolt

4 Spacing tube

Removing, installing

1

Remove left and right footwell trim

2.1

Remove center console

With code FF6 (center console)

AR68.20-S-2000A

2.2

Remove covering

Without code FF6 (center console)

3

Undo bolts (3) at spacing tube (4) and exit spacing tube (4) towards the top

Note installation position

*BA29.10-N-1002-02C

4

Cut off cable tie at electrical wiring harness

Installation: Replace cable tie

5

Pull off condensation-water drain of heater/ventilation housing

6

Push cover (1) at heater/ventilation housing to the left and take it off

7

Remove dust filter (2)

Pull dust filter (2) half way out, bend to the rear and remove.

8

Install in the reverse order

Take care not to damage the felt sealing at the dust filter frame.

Pedal, bearing block

Number

Designation

Model 638

BA29.10-N-1002-02C

Spacing tube bolt at pedestal

Nm

26

Powiązane dokumenty