P54.10-4820-09
Show on model 253.992 |
1a | Charging cable | 3 | Cap | |
1b | Charging cable | 4 | Sequence | |
2 | Charger feed-in socket | 5 | Lock |
Danger | Risk of explosion caused by escaping hydrogen or overheating of the fuel tanks when working on the hydrogen system. Risk of frostbite to body parts caused by escaping gas and by touching component parts carrying gas when emptying fuel tanks. Risk of asphyxiation caused by inhalation of air diluted by hydrogen. Risk of burn injuries by coming into contact with an invisible pale blue hydrogen flame. | ||
Danger | Risk of death when working on component parts and systems with U >= 30 V alternating voltage (AC) or U >= 60 V direct voltage (DC) | Do not touch damaged or defective live component parts and lines or non-insulated electrical connections and lines. | |
Topical note | Notes on fuel cell system | ||
Topical note | General information on handling vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system | ||
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
| Remove | ||
1 | Take charging cables (1a) and (1b) out of the vehicle. | ||
| Check | ||
2 | Check charging cable (1a) over the entire length, plugs and switches for cracks, kinks, bites, cuts, crushed areas, chafe marks and other damage. | If problems occur, | |
| |||
replace charging cable (1a). | |||
After obtaining special order. | |||
3 | Check charging cable (1b) over the entire length, plugs and switches for cracks, kinks, bites, cuts, crushed areas, chafe marks and other damage. | If problems occur, | |
| |||
replace charging cable (1b). | |||
After obtaining special order. | |||
| Install | ||
4 | Place charging cables (1a) and (1b) in vehicle. | ||
| Check | ||
5 | Check charger feed socket (2) for damage. | If problems occur, | |
| |||
Replace charger feed socket (2). | |||
After obtaining special order. | |||
6 | Check that cap (3) is firmly seated on charger feed socket (2). | If problems occur, | |
| |||
Replace charger feed socket (2). | |||
After obtaining special order. | |||
7 | Check drain (4) for clear passage and soiling. | | |
If problems occur, | |||
| |||
rectify the problems. | |||
After obtaining special order. | |||
8 | Check lock (5) by opening and closing cap (3). | If problems occur, | |
| |||
Replace charger feed socket (2). | |||
After obtaining special order. |
Powiązane dokumenty
- ah0000p002201rfw Wskazówki dotyczące systemu ogniw paliwowych
- ah0000z030001a Ogólne wskazówki dotyczące pojazdów z instalacją wysokiego napięcia i/lub akumulatorem litowo-jonowym i/lub gazowym systemem napędu oraz osobistego wyposażenia ochronnego
- ah5400p000101a Wskazówki dotyczące zapobiegania uszkodzeniom elementów elektronicznych na skutek rozładowania potencjału elektrostatycznego
- as0000z003001b Niebezpieczeństwo wybuchu na skutek ulatniania się wodoru lub przegrzania zbiornika paliwa podczas prac przy układzie wodorowym. Niebezpieczeństwo odmrożeń na skutek ulatniania się gazu oraz przy dotknięciu elementów
- as0000z003501a Zagrożenie życia podczas prac przy elementach i systemach U >=30 V napięcie zmienne (AC) bądź U >=60 V napięcie zmienne