AP25.20-B-2981C | Clutch actuation - replace brake fluid | 12.02.16 |
Vehicle 693 with Cumbustion engine 457.920, 457.928, 457.919
Vehicle 696 with Cumbustion engine 457.923, 457.931, 457.924, 475.931
W25.20-0001-06
1 Cover with connection of the bleeding equipment
2 Air bleeder
3 Bleeding flexible tube
Danger! | Intoxication risk by ingestion of brake fluid. Risk of injuries if the brake fluid penetrates the skin or contacts the eyes. | Store brake fluid only in recipients intended for this purpose and duly identified. In order to handle the brake fluid it is recommended to wear appropriate clothes and protective glasses. | |
| Information about the brake fluid. | Valid for all the models. | |
1 | Unfasten the expansion tank hydraulic reservoir's mouth cap and remove by suction the used brake fluid. | The outlet orifice at the hydraulic reservoir bottom must still remain covered by the brake fluid. | |
2 | Connect the bleeding equipment and pay attention so that the hydraulic reservoir is kept supplied with enough fluid to enable the bleeding to be made. | Follow the work instructions recommended by the bleeding equipment's manufacturer. | |
Brake fluid in accordance with the prescriptions about fuels and lubricants, etc. Check IS lubricants | |||
3 | Connect the bleeding flexible hose (3) to the bleeder (2) and at the opposite side to the used brake fluid collecting recipient. | ||
4 | Open the air bleeder (2) in the hydro-servo-pneumatic until the new brake fluid goes out without air bubbles by the flexible bleeding tube (3). | ||
5 | Close the air bleeder (2) and install the protective plug. | ||
6 | Disconnect the air bleeding equipment from the hydraulic reservoir. | Follow the work instructions recommended by the bleeding equipment's manufacturer. | |
7 | Replenish the hydraulic expansion tank up to the specified level and install its cap. | ||
8 | Check the air bleeder's tightness (2). | ||
9 | Carry out the smaller programming procedure in the control unit of the gear shifting management (GS/EPS). | With the code GE1 Electronic traction control. |