P88.50-2510-09
1 Carrier part
2 Front spoiler
4 Speedfix
3 Easy clips
P88.50-2511-01
| Removing | ||
1 | Remove front spoiler | ||
| Remove/install front spoiler | ||
| Install | ||
2 | Paint carrier part (1) and front spoiler (2) | ||
3 | Install front spoiler carrier part (1) | See fig. A. | |
Use standard mounting material | |||
4 | Put up CBS front element in installation position | ||
5 | Position template | See fig. B. | |
6 | Drill dia. 3 mm pilot holes and then drill with dia. 9 mm bit. | Twist drill bit set | |
Drill | |||
7 | Clip both easy clips (3) into the lugs on the front spoiler | ||
8 | Position front spoiler (2) on CBS front element from front | The bottom lugs should arrest in the carrier part (1), the center lugs should be inserted in the carrier part (1). | |
9 | Fasten Speedfix (4) | Ensure that lugs make contact in the inner Speedfix (4) | |
10 | Screw in bolt from inside with enclosed shims through carrier part (1) in front spoiler | Tighten with screwdriver by hand until the front spoiler has the same gap on the fender outside. | |
11 | Install expansion rivet on outer ends of front spoiler from inside | ||
12 | Install front spoiler | See fig. D. | |
| Remove/install front spoiler | ||
Concluding work | |||
13.1 | Add special equipment to the vehicle data card and to the online vehicle data card | Only at workshops without DMS Autoline 8.0 dealer system. | |
Brabus front spoiler (DFO), code E58. | |||
14.1 | Include certificate | ||
| Body kit certification | Models 452.334/432/434 * For Germany only |
Twist drill bit set
450 589 01 70 00