S88.30-4002-06
1 Splash water guard
2 Screws
3 Bracket
4 Bolt
S58.50-4000-01
Illustration shows shop-made metal bracket (thickness of bracket 1 mm)
a 5 mm
b 15 mm
c 50 mm
d 20 mm
e 80 mm
| Installing | ||
1 | Switch vehicle to Service mode | Only model 638.2 See Owner's Manual | |
Danger! | Lethal injuries are possible if vehicle slips off of lifting platform | Align vehicle between lift platform columns and position the four mounting plates at the vehicle jacking points specified by the vehicle manufacturer. | |
| Notes on lifting and supporting | Model 638 | |
2 | Cover all attached parts remaining in vehicle (area to be repaired) | ||
3 | Shop-make metal bracket (3) as shown in illustration | Carry out corrosion protection measure. | |
4 | Install plate nuts at longitudinal member | ||
5 | Bolt on splash water guard (1) | ||
6 | Install plate nut splash water guard (1) | ||
N | Bolt metal bracket (3) onto splash water guard (1) | ||
8 | Align metal bracket (3) and drill a 3 mm hole in the axle-engine subframe | Drill hole in middle of profile of axle-engine subframe. | |
9 | Bolt metal bracket (3) to axle-engine subframe |
Parts ordering notes
Part no. | Designation | Quantity |
A638 524 14 25 | Bulkhead plate | 1 |
A638 988 04 78 | Clamp | 3 |
A201 990 05 36 | Bolt | 4 |
Powiązane dokumenty
- ah0060n010001a Wskazówki dotyczące podnoszenia pojazdu, ustawiania na podporach
- as0000z001001a Zagrożenie życia na skutek ześlizgnięcia lub spadnięcia pojazdu z podnośnika.