P82.61-0473-01
1 Mount antenna for global positioning system (GPS) (20) centered on hinged rear shelf.
P82.61-0479-01
2 Connect battery and extend roof mechanism until rear shelf is upright.
3 Mark dimension h = 110 mm in center of rear shelf and cut out 15 mm dia. antenna hole (21).
4 Mark dimension x = 13 mm from antenna hole (21) and cut out 6 mm dia. hole for antenna lead (b).
5 Cut antenna base plate (23) out of sheet metal panel (approx. 1 mm thick) with size of approx. 100 cm2 and fit to antenna hole pattern below rear shelf.
P82.61-0473-01
6 Screw antenna (20) onto rear shelf together with antenna base plate (23).
7 Connect antenna extension wire (11) and glue connector (24) below rear shelf with felt.
P82.61-0481-01
8 Drill through cast web in rear shelf at interval of approx. 150 mm (arrow).
Size of bit depends on width of smallest cable strap.
P82.61-0480-01
9 Fasten antenna extension wire (11) to cast web with cable strap and glue over with felt strips.
P82.61-0482-01
10 Attach rubber coated cable strap (25) to right rear shelf hinge for holding antenna
lead (11).
P82.61-0483-01
11 Move rear shelf to normal position.
Do not pinch antenna lead.
12 Push fabric cover on right hinge to side and route antenna lead (11) from hinge to rear wall cross member (26) and fasten with cable strap (27).
P82.61-0484-01
13 Open trunk lid.
14 Fasten antenna lead (11) to hydraulic lines with cable strap (28) and route to navigation processor.