Retrofit daytime running lights headlamp

AN82.10-P-0100MCC

Retrofit daytime running lights headlamp

6.12.11



Removing



Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

1

Disconnect battery ground line

AR54.10-P-0003MCC

2

Remove CBS front end (2)

AR88.00-P-1010MCC

3

Remove left front lamp unit (E1)

* not for USA

AR82.10-P-4730MCC

* for USA only

AR82.10-P-4730MCU

4

Adjust the left front seat to the rear

5

Unclip left tweeter from instrument panel and place to one side with electrical line connected

On vehicles up to 30.8.10 with code (C17) Sound package (2 tweeters, 2 bass reflex boxes and diplexer) (FFO) or

On vehicles with code (C54) Sound system 2

AR82.62-P-1000MCC

6

Unclip SAM control unit (N10/10) in front area (arrow A) and fold down to the rear

7

Remove screws/bolts (11) and carefully lower SAM control unit (N10/10) until electrical connectors are accessible



Install

 Danger!

Risk of injury caused by burns to skin and eyes. Risk of poisoning caused by inhaling fumes when working with heat-shrinkable tubing.

Work in well ventilated rooms only. Wear safety glasses with side protection and protective gloves.

AS00.19-Z-0001-01A

8

Retrofit electrical wiring harness (3) for daytime running lights headlamp (1)

AN82.10-P-0100-01MCC

 Wiring harness repair kit, basic

*000589139900

 Expanding pliers

*450589123700

 Puller aid

*450589256300

Hot air blower
gotis://E_15/54_12.0

9

Tighten SAM control unit (N10/10) with screws/bolts (11)

10

Clip SAM control unit (N10/10) into front area (arrow A)

11

Clip left tweeter into instrument panel

On vehicles up to 30.8.10 with code (C17) Sound package (2 tweeters, 2 bass reflex boxes and diplexer) (FFO) or

On vehicles with code (C54) Sound system 2

AR82.62-P-1000MCC

12

Retrofit daytime running lights control units (8)

Cordless drill/driver
gotis://G_58.0_01.1

AN82.10-P-0100-02MCC

13

Retrofit daytime running lights headlamp (1) into CBS front end (2)

 Before installation of the daytime running lights headlamps (1), the primed installation frames (5) are to be painted according to customer request.

AN82.10-P-0100-04MCC

14

Install left front lamp unit (E1)

* not for USA

AR82.10-P-4730MCC

* for USA only

AR82.10-P-4730MCU

15

Install CBS front end (2)

AR88.00-P-1010MCC

16

Connect ground cable to battery

AR54.10-P-0003MCC

17

Deactivate daytime running lights circuit on vehicle

Only on vehicles with code (K06) Daytime running lamps

 Switch off ignition and remove key. Operate headlamp flasher and press "Release" button on key at same time.

A signal tone is emitted to confirm that the daytime running lights are switched off.

18

Place certification in the vehicle

Applies to Europe only



Use for daytime running lamps, certificate

* Applies to Europe only

OF82.10-P-1000-01A

Part no.

Designation

Quantity

DG 98 (see EPC)

Daytime running lights LED parts kit

1