S77.40-0004-04
1-7 Pass holes
8 Drill holes
9 Pass holes
10 Left luggage-rack support
11 Right luggage-rack support
12 Washer
13 Special lining screw
14 O-ring
20 Combined nut M6
23 Safety nut M8
S77.40-0003-01
9 Existing hole
8 Hole to drill from the inside
There is already an oblong hole in the roof frame
a 40 mm
| Removing | ||
1 | Remove C rail | ||
| Installing | ||
2 | Paint the special lining screw (13) the colour of the vehicle | ||
3 | Drill hole (8) with 8.5 plate drill bit | see illustration | |
4 | With a 8.5 steel drill bit, enlarge pass holes (2,3,6,9) | ||
5 | Remove shavings | ||
6 | Treat the mechanised surfaces against corrosion | See paint book | |
2 | Tighten the special lining screws (13) in holes (1,4,5,7) with the combined nuts M6 (20) | ||
7 | Install the luggage-rack support (10,11) |
Instructions for ordering components
Part no. | Designation | Amount |
638 840 00 20 | Left luggage-rack support | 1 |
638 840 01 20 | Right luggage-rack support | 1 |
000125 008413 | Washer | 10 |
913004 008001 | Nut M8 | 10 |
638 990 01 25 | Special lining screw | 6 |
007 997 03 48 | O-ring | 6 |
913023 006002 | Combined nut M6 | 6 |